May be used to fasten the water pump

Corresponds to the original VW part number N90221803

Fits such alternators as on the VR6 engine.

This lightweight pulley only weighs 143g as opposed to the 370g of the original part. This reduction in weight helps reduce rotating mass which translates into increased performance especially at lower rpm.

Made of 6061 T6 Aluminum

NOTE: Please specify whether or not your car has air conditioning when ordering!

Will not fit 120A Alternators! Please order Item # AZVR004 in this case

All Pro Series Head Bolts are cold-forged to ensure molecular integrity, heat-treated prior to thread rolling and machining, and are rated nominally at 190,000 psi. ARP® Pro Series head bolt kits are application specific-designed for use with typically competition only components. These fasteners deliver superior strength and meet the ARP® "ZERO defect-ZERO failure" quality standard. Hardened and parallel-ground washers are included with each kit to ensure even load distribution and accurate torque readings. All Pro Series head bolts have a reduced wrenching 12-point head and wide area flange to eliminate the need for valve train removal for cylinder head retorquing and permits the use of larger diameter valve springs. Most applications have undercut short bolts that can help eliminate head gasket failures through providing more "stretch" to compensate for the additional compression of gaskets.

Set includes all fasteners required for the installation of one cylinder head.

Used to fasten the crank pulley/harmonic balancer on the crankshaft for the VR6

Corresponds to the original VW part numbers N0100873 and N0100875

Corresponds to the original VW part number N90544202 or N90544203

Models:
Golf 1998 >, Bora/Jetta IV 1999 >, Passat 1997 >, Eos 2006>,
Sharan 1996 >, Touareg 2003 >, Phaeton 2003 >,
Transporter 1991 >, T5 6-Zyl. 2004>, A3 6-Zyl. 2004 >,
A8 1994 >, Audi TT 1999 >

Engines:
6-Cyl. fuel-injected (4-Valve), 8-Cyl. fuel-injected (W8), 12-Cyl. fuel-injected (W12).

Used to lock camshafts during removal and installation.

Part #: T10068A (supercedes old part # T10068)

Dimensions: 65 x 28 mm

Corresponds to original part # 1J0853675AAGQF

Size: 65 mm x 25 mm

Corresponds to original part # 1J0853675ADPVQ

Please specify your year, model and engine type when ordering

For motors with plasic valve cover.

Dimensions:
Length 285 mm
Width 240 mm
Height 95 mm
Weight 2.47 kg

Complete set of 20 stretch bolts

Details
VW Sharan V6, VW Sharan V6 4-motion

Type: 7M6, 7M8, 7M9

Direct replacement for original part #:
022103384C (13x)
022103384D (7x)